Tips on how to connect O-ring Chains Remarks to connect basic O-ring Chains

1.A connecting hyperlink of an O-ring Chain for basic application is pre-coated with grease with the pins. Just before connection, verify the grease to the surfaces of pins, and should the volume of grease is compact, apply grease with bare hands. (If gloves are used, the grease will likely be absorbed through the gloves.)
Illustration: Once the connecting link (I) of an O-ring chain for basic application is
shipped, O-rings are fitted in the roots of the pins. If the O-rings come loose resulting from vibration through transport, refit the O-rings in to the roots in the pins.
In this case, you’ll want to return the grease collected on the roots on the pins on the central surfaces with the pins, a lot more at portion A than at portions B proven from the above illustration. (Portions A is worn as a result of sliding with all the bushings.)
two.The chain might be most quickly linked on the teeth of the sprocket. Engage the links at both ends with the chain with all the sprocket teeth and match connecting pins. If your sprocket might be moved, the chain may also be connected to the loosened side.
three. Connecting process
1.Verify that O-rings are attached for the roots of your pins.
2.Should the quantity of grease utilized over the connecting pins is smaller, coat the pins with grease on the central portions.
three.Insert the connecting pins to the bushings of your inner hyperlinks at the two ends.
4.Confirm that the grease is applied on the total face from the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and while pressing the connecting plate, install the spring clip. Confirm whether the head (the end with no split) in the spring clip is turned in the feeding course of your chain. (See the next illustration.)
6.You’ll want to verify the spring clip is securely fitted inside the clip grooves of your connecting pins.
This completes jointing on the connecting website link. Note that grease over the surfaces of connecting pins and O-rings can be eliminated throughout set up perform. In this case, re-grease using the grease over the surface from the base chain or the grease during the polyethylene bag in which the connecting hyperlink was contained.