Power UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE 1
Basic Description
This power unit is intended exclusively to the smaller lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit is extensively applied within the industry of logistic units for instance minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed by the solenoid valve together with the pace controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
General Description
This power unit is created solely for the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and also the velocity controlled through the adjustable needle valve. Once the lift rises to a higher positoin, but the energy supply is reduce, the reducing motion is controlled from the manual override function.
Electrical power UNITS FOR LIFT TABLE three
General Description
This energy unit is designed solely for the huge lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve along with the pace managed by a strain compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This energy unit is built solely for the massive lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve plus the speed controlled by the adjustable needle valve. Once the lift rises to a large positoin, but the electrical power provide is lower, the reducing movement is controlled by the guide override function.
Specific Notes
one. This electrical power unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean the many hydraulic parts concerned just before set up of the electrical power unit.
three. Viscosity of your oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
4. Oil altering is needed following the preliminary a hundred operation hours,afterwards after each 3000 hours.
five. The electrical power unit proven is created to be mounted vertically.